I write you again :)
I need some help... Who can give me a fusebits for Crystal Oscillator 7.3728 mhz
Thank You!
dorcky
Fusebits for Ponyprog https://rom.by/files/fjuzy.jpg
fusebits for Crystal Oscillator 7.3728 mhz
@dark_owl
@Yu-ri
Well...? I`m a little confused :)
Witch one is OK for 7.3728 mhz?
Thank`s
For the installation of fusesbits different programs going on in different ways. These two options are correct. You need to install only the fuses CKSEL0 = 1, CKSEL1 = 1, CKSEL2 = 1, CKSEL3 = 1
Does anyone known if I can use ATMEGA32L-16PU clocked at 7.3728 mhz?
In datasheet say that this type works at 16Mhz, can be used for this project?
Or is imperative to use ATMEGA32L-8PU at 8Mhz.
Thank You!
At a frequency of 7,3728 mhz or 8,0 mhz will work any chip ATmega32. In the datasheet specifies a maximum operating frequency.
dorcky, do not forget to give us a photos of your station )))) It's interesting as well to us.
Sure my friend... when will be ready I will :)
Thank`s for everything ...
Ребята, не поймите меня неверно. Но по моему форум русскоязычный. У же вторую страницу шпарите на английском. Кто хочет знать - пусть русский учит. Переводчиков есть куча. Ладно пару постов написать, но столько уже слишком.
I write you again :)
I need some help... Who can give me a fusebits for Crystal Oscillator 7.3728 mhz
Thank You!
Fusebits for Ponyprog https://rom.by/files/fjuzy.jpg
@Yu-ri
Well...? I`m a little confused :)
Witch one is OK for 7.3728 mhz?
Thank`s
In datasheet say that this type works at 16Mhz, can be used for this project?
Or is imperative to use ATMEGA32L-8PU at 8Mhz.
Thank You!
Thank`s for everything ...